New guy here,
been looking for a compressor tank....
The one in the design here is(if I'm Correct 37.5 X 12".....)
The tank i'm getting it 36 X 16"....
According to what I can figure, the internals should stay the same as the specs here...
should I lower the internals 1.5 inch to keep the top measurement same as drawings...
should I change the internal flue to make it slightly bigger, say 4 X 4 internals instead of 3.5 x3.5" or just leave it as designed...
any help would be appreciated...
Thx
anyone....hello?
Sorry for the slow response. The information is in my free pdf but the gap at the top of the riser is where you adjust your heat pattern. Make all measurements starting from the top down. So, yes, all else equal your opening for the horizontal section should lower to the ground than mine. There's room to play with and that will maintain the proper gap at the top.